This adapter is specially designed to plug into any Bobcat® 7 Pin connector and allow the operator to run up to 1 x 12 volt solenoid directly from the stick controls of your Bobcat®. Works on Bobcat® skid steer loaders as well as Toolcat® and Versahandler® machines.
New: added a latching function. Tap the top left paddle and the unit will latch so you can do your secondary function without having to hold your thumb in place. Tap it again and it releases. Tap the lower paddle and it acts in a momentary function only.
Takes about 1 minutes to install. Is 100% plug and play. This configuration is for plug mount so you can use it over and over on any attachment that has one solenoid to control. This is complete and ready for plug and play directly into any Bobcat® branded machine. It has an indicator LED to show you that you have power and that it is receiving commands from the Bobcat® machine.
What is included:
- 10 x CanBus Controller with 1 output. Up or down control from your left stick.
- 10 x 2 Pin Deutsch connector to connect to your attachment solenoids from the controller.
- Easy to Follow Instructions
This is not just a plug in adapter. There is a microprocessor with software loaded along with a IC driver circuit that enables this to work. That is why it costs more than just a plain old connector.